[ Features | Specifications | Press Release | Buy ]

FirmTek SeriTek/1S2


General System Hardware Requirements
  • PCI based Power Macintosh with available PCI expansion slot
  • Compliant 32-bit PCI bus version 2.2
  • Available hard drive or peripheral power connector
Operating Systems Supported
  • Mac OS 8.xx to Mac OS 9.xx
  • Mac OS X version 10.2 or later
Bus Type
  • 32 bit, 33/66MHz PCI
  • Compliant 32-bit PCI bus version 2.2
Internal Connectors
  • 2-port internal Serial ATA interface connectors support up to 2 hard drives
Drive Types Supported
  • Serial ATA hard drive
  • Backward compatible with Ultra DMA 133/100/66 hard drive*
  • Compatibility issues reported with WD 2TB
ATAPI Device Support
  • Yes*
Data Transfer Rates
  • Up to 150 MBytes/second or 1.5Gbits/second burst data transfer rate
Drive Modes Supported
  • Serial ATA
  • UltraDMA modes 6/5/4/3/2/1/0, PIO modes 4/3/2/1/0*
Advanced Data Features
  • Fully compliant with Serial ATA 1.0a specification
  • Bus Mastering off-loads data I/O handling from CPU
  • Complete 32-bit CRC error checking, for all bits transmitted (command, data, and status), offers enhanced data protection for high-speed Serial ATA drives
  • Dual independent data channels allows for separate device timings
  • Automatically identifies and configures drive types*
  • Automatically detects and supports devices utilizing many transfer modes including UltraDMA 6/5/43/2/1/0, PIO 4/3/2/1/0*
Onboard Flash ROM
  • Allows easy upgrades to the latest firmware
Cables Supported
  • 7-pin SATA cable, either end of cable can be connected to the SATA hard drive or to the PCI host adapter
  • Two year limited parts & labor
Physical Dimensions
  • 120mm x 64mm (W x H) Without bracket
Power Requirements
  • 5V ± 5%
  • Temperature:
    Operating: +5°C to +55°C
    Non-Operating: -25°C to +70°C
  • Relative humidity:
    Operating: 20% to 80%
    Non-Operating: 15% to 90%
EMC Compliance
  • EN55022/1998, EN55024/1998 (European Community)
  • FCC Part 15 Class B (US)
  • RoHS Compliant

* IDE to Serial ATA converter module required for Parallel ATA and Ultra ATA133/100/66 drives